Cli Commands For Examples; Commands For Example 1; Commands For Example 2 - Aerohive HiveAP 20 ag Deployment Manual

CLI C
OMMANDS FOR
This section includes all the CLI commands for configuring the HiveAPs in the previous examples. The CLI
configurations are presented in their entirety (without explanations) for easy copying and pasting. Simply copy the
blocks of text for configuring the HiveAPs in each example and paste them at the command prompt.
Note: The following sections omit optional commands, such as changing the login name and password, and
commands used to check a configuration.

Commands for Example 1

Enter the following commands to configure the SSID "employee" on the single HiveAP in
on page 70:
ssid employee
ssid employee security protocol-suite wpa-auto-psk ascii-key N38bu7Adr0n3
interface wifi0.1 ssid employee
save config

Commands for Example 2

Enter the following commands to configure three HiveAPs as members of "hive1" in
HiveAP-1
hive hive1
hive hive1 password s1r70ckH07m3s
interface mgt0 hive hive1
save config
HiveAP-2
ssid employee
ssid employee security protocol-suite wpa-auto-psk ascii-key N38bu7Adr0n3
interface wifi0.1 ssid employee
hive hive1
hive hive1 password s1r70ckH07m3s
interface mgt0 hive hive1
save config
Deployment Guide
E
XAMPLES
CLI C E
OMMANDS FOR XAMPLES
"Deploying a Single HiveAP"
"Deploying a Hive" on page 73:
87