Table of Contents
Advertisement
Component
USB Port
Status LEDs
MGT and LAN Ethernet Ports
System Fans
Serial Number
AC Power Inlet
On/Off Switch
Power Fan
Ethernet and Console Ports
The two 10/100/1000-Mbps Ethernet ports on the HiveManager labeled MGT and LAN use standard RJ-45 connector
pin assignments that follow the TIA/EIA-568-B standard (see
cable—cat3, cat5, cat5e, or cat6. Because the ports have autosensing capabilities, the wiring termination in the
Ethernet cables can be either straight-through or cross-over.
Figure 2 Ethernet Port LEDs and Pin Assignments
(View of an Ethernet port
on the HiveManager)
Link Rate LED
Dark: 10 Mbps
Green: 100 Mbps
Amber: 1000 Mbps
The Ethernet ports are auto-sensing and can automatically adjust to transmit and receive data over straight-through or cross-over
Ethernet connections. For a diagram showing T568A and T568B wiring, see
Note: The default IP address/netmask for the MGT interface is 192.168.2.10/24, and the IP address of the
default gateway is 192.168.2.254. By default, the LAN interface is not configured.
Deployment Guide
Description
The USB port is reserved for internal use.
The status LEDs convey operational states for the system power and hard
disk drive. For details, see
The MGT and LAN Ethernet ports are compatible with 10/100/1000-Mbps
connections, automatically negotiate half- and full-duplex mode with the
connecting devices, and support RJ-45 connectors. They are autosensing
and automatically adjust to straight-through and cross-over Ethernet
cables. The two ports allow you to separate traffic between the
HiveManager and its administrators from traffic between the
HiveManager and the HiveAPs it manages.
The two system fans maintain an optimum operating temperature. Be
sure that air flow through the system fan vents is not obstructed.
The serial number
The three-prong AC power inlet is a C14 chassis plug through which you
can connect a HiveManager to a 100 – 240-volt AC power source using the
10-amp/125-volt IEC power cord that ships with the product.
The on ( | ) and off (
The fan that maintains the temperature of the power supply.
Link Activity LED
Dark: Link is down
Steady amber: Link is up
Blinking amber: Link is up
8
1
Pin Numbers
"Status LEDs" on page
) switch controls the power to the HiveManager.
Figure
2). They accept standard types of Ethernet
10/100Base-T
Pin
Data Signal
1
Transmit +
2
Transmit -
3
Receive +
4
(unused)
but inactive
5
(unused)
6
Receive -
and active
7
(unused)
8
(unused)
Legend: BI_D = bidirectional
A+/A-, B+/B-, C+/C-, D+/D- = wire pairings
"Ethernet and Console Ports" on page
P
RODUCT OVERVIEW
20.
1000Base-T
Data Signal
BI_DA+
BI_DA-
BI_DB+
BI_DC+
BI_DC-
BI_DB-
BI_DD+
BI_DD-
12.
19
Advertisement
Table of Contents
