Download  Print this page

Troubleshooting - Sanyo CDF-201G Instruction Manual

Compact disc player, excedio series
Hide thumbs

Advertisement

Operation during programmed play
6. If you wish to start playing from a desired programme number, press the program
play button (P, 1, then press one of the SKIP button ( w , w ) until the
desired programme number is indicated on the digital display.
7. If you wish to repeat one programmed track of the disc only, push the repeat
button (RPT). When this function is not worked, all programmed selection are
automatically repeated.
NOTE:
matically cleared.
CAUTION
This player can not be operated with the HOT button pressed to ON while a
cassette tape is playing with the car stereo equipment connected to this player.
A disc can be inserted and loaded, but not played.
The following checks will assist in the rection of most problems which you may
counter with your unit. Should any problem persist after you have made these check
consult
your
nearest
Before going through the check list be first refer back to the connection operating
procedures.
Symptom
No power.
Disc cannot be
loaded
or
ejected.
dealer.
Cause
The car's ignition switch is
not on.
The fuse is blown.
There is already a disc in the
player.
You are trying to put in the
c o m p a c t d i s c b a c k w a r d s .
The shipping screw is not
removed.
The compact disc is extreme-
ly dirty or defective disc.
The temperature in the car
is too high.
Condensation
- 4 -
Solution
If the power supply is con-
circuits, but the engine in not
moving, switch the ignition
key to "ACC".
Replace the fuse with another
5A fuse.
Remove the disc in the player,
then put in the new one.
Insert the Compact disc with
the label side facing up.
Remove the shipping screw.
Clean the compact disc, try
to play the new one.
Cool off the inside of the
car, then try again.
Leave the disc player off for
an hour or so, then try again.
"
_

Advertisement

loading

  Related Manuals for Sanyo CDF-201G

This manual is also suitable for:

Cdf-201a