Troubleshooting - Sanyo ECD-T1137S Owner's Manual

Pll synthesized stereo radio with digital compact disc player
Hide thumbs

Advertisement

TROUBLE SHOOTING
Before going through the check list, check wiring connection. If any of the problems
persist after check list has been made, consult your near est service dealer.
Symptom
No power.
The car ignition switch is
not on.
The fuse is blown.
Disc cannot be
Presence of CD disc inside
loaded or ejected.
the player.
Disc is upside-down.
Compact disc is extremely
dirty or defective disc.
Temperature inside the car
is too high.
Condensation.
No sound.
Volume is in minimum.
Wiring is not properly
connected.
Sound skips.
The installation angle is
more than 30 degrees.
The disc is extremely dirty
or defective disc.
The operation keys The built-in microcomputer
do not work.
is not operating properly
due to noise.
The radio does not
The antenna cable is not
work. The radio
connected.
station automatic
selection does not
The signals are too weak.
work.
Cause
If the power supply is properly
connected to the car accessory
circuits, but the engine is not
running, switch the ignition key
to "ACC"
Replace the fuse.
Remove the disc in the player,
then put a new one.
Insert the compact disc with
the label facing upward.
Clean the disc or try to play a
new one.
Cool off or until the ambient
temperature returns to normal.
Leave the player off for an hour
or so, then try again.
Adjust volume to a desired level.
Check wiring connection.
Adjust the installation angle less
than 30 degrees.
Clean the compact disc, or try
to play a new one.
Press the RESET button. Make
Sure the Front panel is properly
fixed into its place.
Insert the antenna cable firmly.
Select a station manually.
12
Solution

Advertisement

loading

  Related Manuals for Sanyo ECD-T1137S