Install batteries
Initial configuration
6
Smart Home Monitoring | Smart Thermostat | Manufacturer's Installation Guide
Insert the alkaline batteries into the back of
the thermostat. Make sure the polarity of the
batteries is correct. After inserting the
batteries, the display will flash all the
segments, followed by the version number
of the firmware, then display US / CA with a
blinking US.
When configuring the thermostat, press the +
or – button or use the slider ring to cause the
desired value to blink, then press MODE to
select the value. Using the table on the left,
select the country, then the type of system.
After this configuration, the thermostat will
display the Home Screen, and be ready for
attachment to the Mounting Plate.