Install mounting plate
Attach wiring
5
Smart Home Monitoring | Smart Thermostat | Manufacturer's Installation Guide
Remove the Mounting Plate from the back of
the Optima thermostat. Use the included wall
anchors and screws to attach the Mounting
Plate to the wall, making sure the wires run
through the center opening. Use the Trim
Plate vertically or horizontally if desired.
Before attaching the wires, match the wire
(using the labels) to its corresponding
terminal. Refer to the picture of the wiring
taken earlier if necessary.
›
Open the terminal by lifting the latch up.
›
Push each wire into the hole of the
terminal and push the latch down to
secure the wire.