Advertisement
!
Install&Batteries&
Insert the alkaline batteries into the back of the
thermostat. Make sure the polarity of the
batteries is correct. After inserting the batteries,
the display will flash all the segments, followed by
the version number of the firmware, then display
US / CA with a blinking US.
Initial&Configuration&
When configuring the thermostat, press the + or – button or use the slider
ring to cause the desired value to blink, then press MODE to select the value.
Using the table at right,
Value
select the country, then
US
the type of system.
CA
After this configuration,
the
thermostat
will
HP
display
the
Home
NON-HP
Screen, and be ready
O
for attachment to the
B
Mounting Plate.
FAN HE
FAN HG
Description
United States – Configures thermostat for
use in the US.
Canada – Configures thermostat for use
in Canada
Heat Pump
Non Heat Pump – Gas, electric, or oil heat
Heat Pump with O reverse valve
Heat Pump with B reverse valve
Non-HP: Electric or Oil Heat
Non-HP: Gas Heat
5
!
Attach&Thermostat&To&Mounting&Plate&
Attach the thermostat to the Mounting Plate
by aligning the connector pins and the plastic
retention posts and pushing the thermostat
onto the Mounting Plate.
Make sure the connector pins are not bent
and that the thermostat is fully seated on
the Mounting Plate.
Turn&Power&Back&On&To&The&
HVAC&System&
Go to the electrical service panel or
furnace switch and turn the HVAC
system back on.
Configure&Thermostat&
The thermostat can now be used as a basic local thermostat. To enable the
enhanced features, additional settings need to be configured, such as pairing
with a connected home system. See the Configuring the Thermostat section in
the User's Manual for more details.
6
Advertisement
