Data - Yamaha Genos Reference Manual

Punch In/Out Recording—Replace or Overdub a Certain Range of the

Data

This method of recording can only be used on an existing recording. It allows you to re-record over a specific part of
the already-recorded material. You can replace the original part with the new recording by Punch In/Out recording, or
keeping the original and mixing it with the new by Punch In/Out recording with the overdub enabled. This lets you
either correct a mistake in the recording or overdub new parts onto the original recording.
Keep in mind that sections before and after the Punch In/Out section of the track are not recorded over and remain as
the original data—but they play back normally to guide you in and out of the recording.
NOTE
When you re-recording the file by Punch In/Out method, we recommend re-recording only one range at one time. This is because the Undo/Redo function can undo/redo
only one range that was recorded immediately before.
Start Recording
1
To select the desired file, execute Steps 1–3 in "Selecting a Multi Track Audio File (.aud)"
on page 91.
2
Select the desired track to be re-recorded, by touching [Rec] corresponding to the track.
3
Set the recording mode.
3-1
Set the parameter "Rec Mode".
Select the desired Punch In/Out mode, according to how you want to trigger recording.
• Manual Punch In/Out: This lets you manually execute Punch In/Out recording by operating on the dis-
play.
• Pedal Punch In/Out: This lets you manually execute Punch In/Out recording by using a connected foot-
switch to the ASSIGNABLE FOOT PEDAL 2 jack.
• Auto Punch In/Out: This lets you automate Punch In/Out recording, by specifying the recording range in
advance (see below).
3-2
Set the "Overdub" checkbox off/on.
• Off: Replace a certain range of the data on the track.
• On: Mix the new recording to the existing data in a certain range on the track.
NEXT PAGE
96
Genos Reference Manual
Original Data Re-recorded Data
Punch In
Original Data
Punch Out Stop Recording