Assembly-Assigning The Source Pattern To Each Channel; Channel Edit - Yamaha Genos Reference Manual

Assembly—Assigning the Source Pattern to Each Channel
The explanations here apply to step 4 of the Basic Procedure on
channel data of the current Section has been copied from which Style, which Section, and which channel. For each
channel, touch the Style name, Section name, or Channel name as necessary to select the desired one.
NOTE
• An Audio part cannot be copied from another Style. If you want to use a specific Audio part, make sure to select the corresponding Audio Style before calling up the Style
Creator display.
• If you select an Audio Style as starting data, the Audio part cannot be replaced with different data.
NOTICE
The edited Style will be lost if you change to another Style or turn off the power to the instrument without carrying out the Save operation (step 7
on page 14).

Channel Edit

The explanations here apply to step 5 of the Basic Procedure on
already recorded channel data. Select the Target channel then edit the desired parameters.
After editing the desired parameter, touch [Execute] to actually enter the edits for each setup window. When execution
is completed, this button changes to [Undo], letting you restore the original data if you are not satisfied with the
results. The Undo function only has one level; only the previous operation can be undone.
NOTE
If you select an Audio Style as starting data, the Audio part will be used as is. The Audio part cannot be deleted, edited or created from scratch.
page 14. The "Assembly" display shows that each
page 14. The "Channel Edit" display lets you edit the
Genos Reference Manual
1
19