L2Protocol Tunnel Dot1Q - HPE FlexNetwork 5130 EI Series Command Reference Manual

MVRP
PAGP
PVST
STP
Tunnel
VTP
UDLD
Table 61 Command output
Field
Encapsulated
Decapsulated
Forwarded
Dropped

l2protocol tunnel dot1q

Use l2protocol tunnel dot1q to enable L2PT for a protocol.
Use undo l2protocol tunnel dot1q to disable L2PT for a protocol.
Syntax
In Layer 2 Ethernet interface view:
l2protocol { cdp | dldp | eoam | gvrp | lacp | lldp | mvrp | pagp | pvst | stp |
udld | vtp } tunnel dot1q
undo l2protocol { cdp | dldp | eoam | gvrp | lacp | lldp | mvrp | pagp | pvst |
stp | udld | vtp } tunnel dot1q
In Layer 2 aggregate interface view:
l2protocol { gvrp | mvrp | pvst | stp | vtp } tunnel dot1q
undo l2protocol { gvrp | mvrp | pvst | stp | vtp } tunnel dot1q
Default
L2PT is disabled for all protocols.
0 0
5 1
0 0
5 5
N/A N/A
0 6
0 0
Description
Number of encapsulated packets.
The number increases by 1 when the interface receives and encapsulates a
protocol packet from a customer network.
For protocol Tunnel, which represents tunneled packets, this field displays N/A.
Number of decapsulated packets.
The number increases by 1 when the interface receives and decapsulates a
tunneled packet from the service provider network.
For protocol Tunnel, which represents tunneled packets, this field displays N/A.
Number of forwarded packets.
The number increases by 1 when the interface receives a protocol packet and
forwards it.
The number increases by 1 for protocol Tunnel when the interface receives a
tunneled packet and forwards it. If no interface of the PE is connected to
customer networks, the number does not increase.
Number of dropped packets.
The number increases by 1 when the interface receives a protocol packet and
drops it. Protocol packets dropped by hardware are not counted.
The number increases by 1 for protocol Tunnel when the interface receives a
tunneled packet and drops it.
0
7
0
5
100
0
0
296
0
3
0
0
10
0
0