Vlan Commands; Basic Vlan Commands; Bandwidth; Default - HPE FlexNetwork 5130 EI Series Command Reference Manual

VLAN commands

Basic VLAN commands

bandwidth

Use bandwidth to set the expected bandwidth of an interface.
Use undo bandwidth to restore the default.
Syntax
bandwidth bandwidth-value
undo bandwidth

Default

The expected bandwidth (in kbps) is the interface baud rate divided by 1000.
Views
VLAN interface view
Predefined user roles
network-admin
Parameters
bandwidth-value : Specifies the expected bandwidth in the range of 1 to 400000000 kbps.
Usage guidelines
The expected bandwidth is an informational parameter used only by higher-layer protocols for
calculation. You cannot adjust the actual bandwidth of an interface by using this command.
Examples
# Set the expected bandwidth to 10000 kbps for VLAN-interface 1.
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] bandwidth 10000
default
Use default to restore the default settings for a VLAN interface.
Syntax
default
Views
VLAN interface view
Predefined user roles
network-admin
169