Table of Contents
Advertisement
Chapter 6
CLI – Layer 2
show boot bank
Use the show boot bank command to display the software bank from which the
switch will boot at the next boot process. This command should be issued separately
for each switch in the stack using the session command.
Note: This command is not supported by the P333R and P333R-LB switches.
Note: If this command is to be implemented on a switch other than the stack master,
a session should be opened to the relevant switch.
The syntax for this command is:
show boot bank
Output Example:
show boot bank
Boot bank set to bank-a
show module
Use the show module command to display switch status and information. For
each switch with an expansion sub-module installed, both switch and expansion
sub-module type and information are shown.
The syntax for this command is:
show module [<mod_num>]
mod_num
Output Example:
P330-N> show port flowcontrol 3/2
Mod
--- ------------------
1
P333T
X330GT2
P330STK
BUPS
2
P333T-PWR
58
(Optional) Number of the switch/expansion sub-module. If
you do not specify a number, all switches/expansion sub-
modules are shown.
Type
C/S
----
1.0
2.0
2.0
3.0
S/N
Statuses
--------
----------------------------
4144162
PS:OK Fans:OK Mode:Layer2
Conn-Up:Fail Conn-Down:Ok
BUPS:Not Prsnt Fans:None Type:None
4455428
PS:OK Fans:OK Mode:Layer2
Avaya P332MF User's Guide
Advertisement
Table of Contents
