set device-mode
Use the set device-mode command to change the Basic Mode of Operation of
the P332-ML/P332GT-ML/P333R/P333R-LB switches between Router and Layer 2
modes.
Note: This command is not supported by the P333T/P334T/P332MF switches
which do not have Router mode.
The syntax for this command is:
set device-mode <mode>
mode
set interface
Use the set interface command to configure the management interface on the
Master agent of the stack.
The syntax for this command is:
set interface inband <vlan> <ip_addr> <netmask>
inband
vlan
ip_addr
netmask
Output Example:
P330-N# set interface inband 1 192.168.42.252 255.255.255.0
Interface inband IP address set.
You must reset the device in order for the change to take effect.
Avaya P332MF User's Guide
Router | Layer2
Interface name used for the management
The number of the VLAN to be used for management
IP address used for managing the stack
Subnet mask of the management interface
Chapter 6
CLI – Layer 2
97