ThyssenKrupp Flow2A Installation Manual page 27

Rotation:
A rotation is only possible with an automatic swivel.
A rotation can only been programmed at a halt position. The rotation starts when the stair lift is at a
halt position. This to ensure that the user rotates away from the stairs and can get out of the chair
safely.
3.15.2 Test drive mode -2-:
When all the raildata has been entered, a test ride can be made in mode -2- using the installation
joystick. This should be done with an empty chair as some parts the safety system is still switched off.
When a control unit is controlled, the display shows which unit. Also the battery voltage is shown when
the "E" button is briefly pressed in mode -2-.
3.15.3 Setting the swivel offset in mode -5-:
Mode -5- can be used to set an offset to the swivel position. This is done in the factory and should not
have to alter in the field.
If needed:

Enter mode -5-

With "D" and "I" the swivel offset can be altered

Press and hold the "E" button until the "PING" will store the value.
3.15.4 Functions mode -9-:
For other settings and functions in mode 9, please refer to tab 6, systematic fault finding and tab 2,
system description.
27