ThyssenKrupp Flow2A Installation Manual page 13

The lift will go out of the service modes when no command has been given for 5 minutes, it will then
return to normal operation mode.
The password does not have to be re-entered when going through service modes and resetting the lift,
as long as the lift doesn't go into sleep mode after 2 minutes of no operation (while in normal
operation mode) or has been driven for 5 minutes.
Before putting in the fuse, please check that all
connectors are properly connected to the
control board, service board and sensor board.
Remove the front (service) cover and put the 30A
fuse into the drive (right side next to battery) and
switch the drive on by slightly pulling out the red
tab on the back. (A spark is normal when
inserting the fuse)
Check that the blue led on the front is lit. Enter
service mode:

Press the middle (E - enter) button at least 5
seconds, until 0.00 appears in the display.

The number with the dot next to it can be
altered, left button -> "D" - decrement, right
button -> "I" - increment. The digit can be
selected by moving the dot with the Enter
button from left to right.

Enter the password: "245" with use of the
buttons (e.g. press "I"-increment twice for
number 2, repeat for 4 and 5).

Now enter the service mode by pressing the
middle button again for 5 seconds.

You should now be in service mode -2-.

The horizontal lines next to the number 2 are
blinking, indicating that you are in the main
menu.

By pressing the "D" and "I" buttons a menu
can be selected.

For installation, press the "I" button once, so
-3- is displayed.

Now press the "E" button to enter mode -3-.

The horizontal lines next to the number 3 are
now continuous lit.
13