Height Of The Footrest - ThyssenKrupp Flow2A Installation Manual

3.9 Height of the footrest

The position of the footrest depends on the height of the chair base. The following rule of thumb
applies for setting the height of the footrest:

An increase of one position of the seat height is accompanied by setting the footrest one
position lower. To move the footrest one position lower, the footrest shaft must also be moved
one position lower and the linkage one position higher.
CAUTION

The centre position is marked on the linkage by a rectangle (□ ) and on the footrest by
an arrow (►).
1. Lay the chair and use a clamp, as necessary,
to stop the chair base from folding up.
2. Adjust the linkage following the rule of thumb
by unscrewing the m6xl6 bolt and sliding the
linkage out. The post is in position 3.
3. Remove the two brackets by unscrewing the
M6x16 bolt and sliding them out of the
frame.
4. Set the correct position of the footrest shaft
higher or lower than position 3, according to
the rule of thumb.
5. Secure the linkage and the brackets again
with an M6x16 bolt.
19