Integrated Peripherals Submenu Options; Table 3-4 Bios Setup Integrated Peripherals Submenu Options - Fujitsu Stylistic 2300 Technical Reference Manual

Integrated Peripherals Submenu Options

Configuration options for the Integrated Peripherals submenu are given in Table 3-4. Note that some
peripheral interfaces are only available when using a device attached to the system interface port such as
the Stylistic 1200 port replicator.

Table 3-4 BIOS Setup Integrated Peripherals Submenu Options

Option
Serial Port A
Base I/O Address
Interrupt
Serial Port B
Device
Base I/O Address
Interrupt
2nd Base I/O Address
FIR DMA Channel
Settings
Disabled
Enabled
Auto
3F8
2F8
3E8
2E8
IRQ 3
IRQ 4
IRQ 10
IRQ 11
Disabled
Enabled
Auto
IrDA
FIR
System Interface Port
3F8
2F8
3E8
2E8
IRQ 3
IRQ 4
IRQ 10
IRQ 11
100
108
110
118
DMA 1
DMA 3
Description
Determines whether serial port A is active and the
method used to configure serial port A.
Select Auto to allow the BIOS or operating system to
configure the port automatically. Select Enabled to
configure the Base I/O Address and Interrupt options
manually in BIOS setup. Select Disabled to turn
serial port A off.
Determines the base I/O address used for serial port
A. The Serial Port A option must be set to Enabled
before this setting can be changed.
Determines the interrupt request level used for serial
port A. The Serial Port A option must be set to
Enabled before this setting can be changed.
Determines whether serial port B is active and the
method used to configure serial port B.
Select Auto to allow the BIOS or operating system to
configure the port automatically. Select Enabled to
configure the Base I/O Address and Interrupt options
manually in BIOS setup. Select Disabled to turn
serial port B off.
Determines which physical interface serial port B is
assigned to. Select IrDA to use the IrDA port in
Standard IR (SIR) mode (115 Kbps). Select FIR to
use the IrDA port in Fast IR mode (4 Mbps). Select
System Interface Port to assign serial port B to the
serial port B connector on the port replicator.
Determines the base I/O address used for serial port
B. The Serial Port B option must be set to Enabled
before this setting can be changed.
Determines the interrupt request level used for serial
port B. The Serial Port B option must be set to
Enabled before this setting can be changed.
Determines the 2nd base I/O address for serial port
B. This option is only selectable when the Serial Port
B Device setting is FIR.
Determines the DMA channel assigned to serial port
B when using Fast IR mode. This option is only
selectable when the Serial Port B Device setting is
FIR.
BIOS Setup
Microsoft Corp. Exhibit 1020
3-9