Table of Contents
Advertisement
EXTENSION WING INSTALLATION
The extension wings are heavy; two
people are required for assembly.
1.One person is required to lift an extension wing into
position. The extension wing will sit into alignment
pins to help locate the postion.
2. The second person will install two spacers
7)
into the table slot to ensure proper miter guage
operation.
3. Have the second person secure the extension wing
in place using four 5/16"-18 x 45mm hex socket
bolts, four M8 lock washers and four special wash-
ers. Bolts and washers will install up from inside
the cabinet into the bottom of the extension wing.
SEE FIG. 8.
TABLE LEVELING ADJUSTMENT
T
he pre-adjustment and setting of the extension
wings for level and flatness have been performed at
the factory. Follow the instructions below if further
adustment is needed.
1. Use a long and accurate straight edge to check
table level and flatness. Place the straight edge
onto the main table and check each wing separate-
ly and then all three castings at once. This will
ensure that the wings are level with the main table
as well as each other. SEE FIG. 9.
2. Loosen the four small set screws (A-Fig. 10) on
the side of the frame casting using a 2.5mm Allen
wrench.
3. Next, loosen slightly the four 5/16"-18 x 45mm hex
socket bolts (B-Fig. 10) previously used to attach
extension wings to the saw body.
4. Adjust the four thin elevation bolts found between
the top of the frame casting and the underside of
the extension wing using the 5/8" opening of the
blade wrench. SEE FIG. 10.
5. Check progress periodically with the straight edge
using steps described in the first step above.
6. Once the table level and flatness is achieved
tighten the four 5/16"-18 x 45mm hex socket bolts
and then the four small set screws on the side of
the frame casting to retain the setting.
ASSEMBLY
A
(A-Fig.
Front Bolts
12
FIGURE 7
(x2)
FIGURE 8
FIGURE 9
THIN BOLTS
A
BLADE
B
WRENCH
FIGURE 10
Rear Bolts
(x2)
Advertisement
Table of Contents
