CyberData 011049 Operation Manual page 46

2.3.7.2 Point-to-Point Configuration
When the board is set to not register with a SIP server (see
device to dial out to a single endpoint.
In this case, the dial-out extension should be the IP address of the remote device. The device can
also receive Point-to-Point calls. The delayed DTMF functionality is available in the Point-to-Point
Mode.
Note
Operations Guide
Receiving point-to-point SiP calls may not work with all phones.
Figure 2-18. SIP Configuration Page Set to Point-to-Point Mode
Device is set to NOT register with a SIP server
10.0.1.40
930801F
Installing the SIP Call Button
SIP Call Button Setup
Figure 2-18), it's possible to set the
CyberData Corporation
38