Restore The Factory Default Settings - CyberData 011049 Operation Manual

2.2.6 Restore the Factory Default Settings

2.2.6.1 RTFM Switch
When the SIP Call Button is operational and linked to the network, use the Reset Test Function
Management (RTFM) switch
Note
Note
RTFM
To set the factory default settings:
1. Press and hold the RTFM switch until the button LED starts blinking rapidly (about 10 seconds),
Operations Guide
(Figure
Each SIP Call Button is delivered with factory set default values.
The SIP Call Button will use DHCP to obtain the new IP address (DHCP-assigned address
or default to 10.10.10.10 if a DHCP server is not present).
then release the RTFM switch.
2-8) to set the factory default settings.
Figure 2-8. RTFM Switch
930801F
Installing the SIP Call Button
SIP Call Button Setup
CyberData Corporation
14