11. Measuring operations
11.1.3 Dual display
On all double-function sensors incorporating
a temperature sensor on the first channel the
temperature value can be displayed at the
same time in the function field.
Select 2nd channel,
To activate the temperature display
press and hold down key
To return to the channel display
press and hold down key
11.2 Peak values memory
From all the measured values acquired for
each measuring point the highest and the lo-
west values are continuously recorded.
display these high / low peak values the
desired channel must be set (see 7.1) and
then key
or
◄
►
The display also includes the associated
symbol.
To display the maximum value briefly press key
To display the minimum value briefly press key
To delete the maximum value press and hold down key
To delete the minimum value press and hold down key
To return to the measuring point display briefly press key
Whenever this data is deleted, the current measured value will, since measu-
ring is a continuous process, appear again immediately.
12. INTERFACE
If measuring instrument ALMEMO
data cable ZA1919-DKU5, this interface is used not only to power the device
but also to program it and output all its data. (see Man. 6.)
The data cable must be plugged in at the DC socket (3). The baud rate is pro-
grammed on leaving our factory to 9600 baud; this setting should not be alte-
red. (see Man. 5.2)
So long as a data cable is connected, wireless transmission remains disabled.
13. DEVICE CONFIGURATION
On measuring instrument ALMEMO
configured. To access configuration press
show - instead of the units - the abbreviations for the various parameters, one
22
ALMEMO
.
▲
.
▲
must be pressed.
®
2790
®
To
2790 is connected to a computer via USB
®
2790 a number of parameters can be
.
FCT
◄
►
◄
►
▲
The display should then