Sonda Lambda - Orlanski ORLIGNO 100 16kW User And Service Manual

13.1 Sonda Lambda

Lambda sensor we can connect to the system in two ways:
– directly to the controller, if the entire system with CAN bus module will only use Lambda oxygen
sensor,
– through enlargement module I/O with the number 5, if in the system there are other modules
enlargement.
After connecting the module configure the controller yet. For this purpose, proceed as explained
below.
From the main menu select SETTINGS
Then in the mode SERVICE enter the access code
After inputting the correct code, run the MODULES CONFIGURATION
56