Burner; State - Orlanski ORLIGNO 100 16kW User And Service Manual

12.5.4.2 System configuration
Menu is used to configure the heating system (hydraulic). The possibility of settings is dependent
of number of expansion modules connected in the system.
WARNING!
You must first configure the modules..
Function
Number of CH circuits
Number of HW circuits
Number of buffers
Outside temp. sensor
Return temp. sensor
Solars
12.5.4.3 Restore to factory settings
This function allows the controller to restore the factory settings.
WARNING!
Will be restored all factory settings, which can cause your system to malfunction.
After restoring the factory settings may be need to reconfigure the controller settings.

12.6 Burner

12.6.1. State

44
SYSTEM CONFIGURATION
Specifies the number of heating circuits in the system.
Specifies the number of hot water circuits in the system.
Specifies the number of buffors in the system.
Specifies if in the system is installed outside temperature
sensor (module 0).
Specifies if in the system is installed return temperature
sensor (module 5).
Specifies if the system is equipped with solar collectors.
Description