Final Connection; Treadmill To Dt5 Desk Assembly - LifeSpan TR800-DT5 Owner's Manual

Final Connection

Treadmill to DT5 Desk Assembly

A. Position the pre-assembled treadmill as shown below.
B. Lift the rear of the treadmill and roll it forward under the desk until the
treadmill is in the desired position.
Lift
Desk D-Connector
9 Pin
Data Cable
C. Connect the 9 Pin Data Cable(2) into the desk D-Connector on the Right
Base Foot(7) and treadmill Console Port and tighten the thumb screws.
D. Plug the Power Cord into the treadmill Power Receptacle and wall outlet.
F. Turn the treadmill Power Switch on.
36
Roll Forward
Treadmill Connections
7
2
Be sure all connectors
are plugged in prior to
connecting the power cord
Power Switch
Power Receptacle
Console Port
NOTE: