LifeSpan TR800-DT5 Owner's Manual page 23

Desk Assembly
Step 4: Attach the Desktop Reinforcement Frame to the Right and Left Legs
LOCATE BAG
LABELED 4
Contents: 4 each M8x70L
Bolts,Washers and Nuts
A. Align the Desktop
Reinforcement Frame(1)
with Right Leg(4). The
Desktop Mounting Flanges
should be facing up as
shown in illustration.
B. Carefully attach the
Desktop Reinforcement
Frame(1) to the Right
Leg(4) by loosely installing
the two M8 x 70L Bolts,
Washers, and Nuts(14) as
shown in the illustration.
Be sure that the wire
harness from the Leg and
the Reinforcement Frame
are routed out through the
space provided.
C. Connect the 7-pin wire
harness cables and
carefully tuck excess wire
into the Reinforcement
Frame(1).
D. Repeat Step B with Left
Leg(5).
NOTE: Do not fully
tighten the four M8 x
70L bolts and nuts at this
time. Keeping them loose
will help with
the next step in the
assembly process.
28
1
Desktop
Mounting
Flanges
4
Step 4A
1
4
13mm Open
Step 4B, 4C
After Connecting
W ires Tuck Inside
Frame in Space
Provided
Connect the
wires
M8x70L (x4)
Wrench