Step 5: Attach the Leg Assembly to the Desktop
LOCATE BAG
LABELED 5
Contents: 8 each M6x15L
Screws with Washers
Brackets with the mounting holes in the Desktop and loosely install the
M6 x 15L Screws(15) into each Desktop Support Bracket first.
D. Install the remaining two M6 x 15L Screws(15) into the Desktop
Reinforcement Bracket.
E.
Tighten all eight M6 x 15L Screws.
F.
Tighten the four M8 x 70L Bolts, washers and nuts previously installed in
step 4 B & D.
NOTE:
Be sure to line
everything up
exactly as shown in
the illustration.
A. Lay the Desktop(3) on a clean non-
abrasive surface with the bottom side up.
B. Set the Leg Assembly on the bottom of
the Desktop as shown in the illustration.
C. Line up the holes in the Desk Support
Desk Assembly
M6x15L Screw
(x8)
4mm
29