Static Multicast - TP-Link T2500-28TC User Manual

The following entries are displayed on this screen:
Port Config

Select:
Port:
Filter:
Filter Mode:
Filter IDs:
Max Groups:
LAG:
Note:
1. If the Max Groups value is set less than the current value, some groups may be deleted to
satisfy the restriction.
2. The max number of filter entries on each port is 15.

10.2.5 Static Multicast

On this page you can configure static multicast groups. The multicast groups configured here are
not learned by MLD Snooping and independent of dynamic multicast groups and multicast filters.
The static multicast member ports won't age out.
Choose the menu Multicast→MLD Snooping→Static Multicast to load the following page.
Figure 10-17 Port Config
Select the port you want to configure.
Displays the port number.
Choose to enable or disable filter function in this port.
Choose the filter action mode. You can accept or
refuse Report message with specific multicast groups
specify by the filter IDs.
Enter the filter IDs with this port. The filter IDs are
configured in Filer Config. The format is 1,4,12.
Enter the maximum groups which the port can join as
the member port. It ranges from 0 to 256.
Displays the LAG number.
165