TP-Link T2500-28TC User Manual page 261

The following entries are displayed on this screen:
SNMP Traps

SNMP
Authentication:
Coldstart:
Warmstart:
Link Status:
CPU Utilization:
Memory Utilization:
Figure 14-9 Traps Config
If selected, the switch will send an SNMP Authentication trap
when a received SNMP request fails the authentication.
If selected, the switch will send a Coldstart trap when it is rebooted
with the SNMP function enabled.
If selected, the switch will send a Warmstart trap when you enable
the SNMP function.
If selected, the switch will send a Link Status trap when the
up/down status of the port changes.
If selected, the switch will send a CPU Utilization trap when the
CPU utilization rate is over 80%.
If selected, the switch will send a Memory Utilization trap when the
memory utilization rate is over 80%.
251