Table of Contents
Advertisement
Chapter 1
Introduction
1
Figure 1: Front Panel
1. Power Module Indicator LEDs
6. Port Status Indicator LEDs
RS232 Serial Console Port
Management Port
Alarm Indicator LED
Power Module Indicator LEDs
Port Status Indicator LEDs
MicroSD Port
2
1
2. RS232 Serial Console Port
This port is for interfacing directly with the device and access initial management functions.
This 10/100Base-T Ethernet port is used for system management that is out-of-band from
the switch fabric.
The alarm indicator LED illuminates when an alarm condition exists.
These LEDs indicate the status of the power modules. The top LED indicates the power
supply is supplying power. The bottom LED indicates the power supply is receiving power.
These LEDs indicate when ports are active.
This port houses the microSD card containing the firmware and configuration for the device.
2
3
3. Management Port
4. Alarm Indicator LED
Configuration Ports and Indicator LEDs
RUGGEDCOM RSG2488
Installation Guide
4
5
5. MicroSD Port
6
Advertisement
Table of Contents
