Part 2: DECT Hardware Installation & Programming
Starting the DECT 1500 System
1. Install the CCFP administration software on an IBM-compatible PC.
2. Make sure that all RFPs are connected correctly. Also, make sure that all IWU
connections are made to PABX lines.
3. Connect a serial cable (RS-232) between the CCFP and the PC installed with
the administration software.
4. Connect the power cable to the CCFP. Ensure that there is an earth connec-
tion in the power supply plug.
5. Power up the CCFP.
6. Use the administration program to:
• Configure the system.
• Make a cable measurement to all installed RFPs.
• Adjust IWU parameters as required.
• Register each handset to the system.
32