ComAp IG-NT Reference Manual page 281

remote terminal using the command ExtValue 4.
Binary input: ExtValue4 down
Related FW 3.0
Description IS-NT specific function
While this input is active the value of ExtValue 4 is contiously beeing decreased at
the rate of
N
OTE
If this input is used (configured), the ExtValue 4 can't be written remotely from a
remote terminal using the command ExtValue 4.
Binary input: ExtValue1reset
Related FW 3.0
Description The ExtValue 1 is reset to it's default value when this input is activated and held
there until the input is deactivated. The default value is given by the setpoint
ExtValue1deflt.
While the reset input is active:
N
OTE
Configuring of the reset input does not block writing the ExtValue remotely, in
comparison to the up and down inputs, which does. However, if the reset input is
active, the remotely written data are not accepted.
Binary input: ExtValue2reset
Related FW 3.0
Description The ExtValue 2 is reset to it's default value when this input is activated and held
there until the input is deactivated. The default value is given by the setpoint
ExtValue2deflt.
While the reset input is active:
N
OTE
Configuring of the reset input does not block writing the ExtValue remotely, in
comparison to the up and down inputs, which does. However, if the reset input is
active, the remotely written data are not accepted.
Binary input: ExtValue3reset
Related FW 3.0
IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
ExtValue4 rate until it reaches ExtValue4LoLim.
:

The value does not respond to up and down inputs.

The value does not accept new data that are written remotely from a
remote terminal using the ExtValue command.
:

The value does not respond to up and down inputs.

The value does not accept new data that are written remotely from a
remote terminal using the ExtValue command.
:
281