Jungheinrich ECE 220 Standard Operating Instructions Manual page 43

Setting procedure for trucks with and without indicator instrument (CANDIS (o)):
– Enter the three-digit parameter number and confirm with Set key (22).
– The indicator instrument (CANDIS (o)) continues to display the operating hours. If
the display changes, cancel the setting procedure with the o-key (26) and restart
from the beginning.
– Enter or change the setting value according to the parameter list and confirm with
Set key (22).
Z
When the input is incorrect, the LED (21) of the o-key (26) lights up red. After enter-
ing the parameter number again, the setting value can be entered or changed.
Repeat the procedure to enter further parameters. To terminate the input, press the
o-key (26).
The following parameters can be entered:
Code lock parameter list
No.
Codeschloss
000 Change master code
The length of the master
code (4 to 6 digits) also
determines the length (4
to 6 digits) of the operator
code. As long as operator
codes have been
programmed, only new
codes with the same
length can be entered. If
the code length is to be
changed, all operator
codes must be deleted
first.
001 Add operator code
(max. 600)
E 20
Function
000000 - 999999
000000 - 999999
Range
Setting value
0000 - 9999
or
00000 - 99999
or
0000 - 9999
or
00000 - 99999
or
Default Comments
Setting Work flow
value
7295 (LED 23 flashes)
Enter the current
code
confirm (Set)
(LED 24 flashes)
Enter a new code
confirm (Set)
(LED 25 flashes)
Repeat new code
Confirm (Set)
2580 (LED 24 flashes)
Enter a code
confirm (Set)
(LED 25 flashes)
Repeat the code en-
Confim (Set)
try