Jungheinrich ECE 220 Standard Operating Instructions Manual page 40

Commissioning
After switching on the master switch and, if required, the key switch, the LED (21)
lights up red.
After entering the correct operator code (factory setting 2-5-8-0) the LED (21) lights
up red.
When an incorrect code has been entered, LED (21) lights up red for two seconds.
After that you can enter a new code.
Z
The Set key (22) has no function in operating mode.
Switching off
The truck is switched off by actuating the
o -key (26).
Z
The truck can be switched off automatically
after a preset time. For that purpose the cor-
responding code lock parameter must be set
(refer to section 5.4).
23
24
1
4
7
Set
22
21
25
2 3
5 6
8 9
26
0
E 17