Chrysler PACIFICA 2018 User Manual page 137

Tether Strap Anchorages (Third Row
60/40 Anchorage Shown)
LATCH-compatible child restraint systems will be
equipped with a rigid bar or a flexible strap on each
side. Each will have a hook or connector to attach to
the lower anchorage and a way to tighten the con-
nection to the anchorage. Forward-facing child re-
straints and some rear-facing child restraints will also
be equipped with a tether strap. The tether strap will
have a hook at the end to attach to the top tether
anchorage and a way to tighten the strap after it is
attached to the anchorage.
Center Seat LATCH
This vehicle has 4 lower LATCH anchorages in the
third row, rear seat. Anchorages A and B are used
for the right outboard position behind the front
passenger (1). Anchorages C and D are used for the
center seating position (2). The left outboard posi-
tion (3) does not have lower anchorages. Do not
install a child restraint using anchorages B and C.
This is not a LATCH position in your vehicle.
Center Seat LATCH Positions
If a child restraint installed in the center position
blocks the seat belt webbing or buckle for the out-
board position, do not use that outboard position. If
a child seat in the center position blocks the out-
board LATCH anchors or seat belt, do not install a
child seat in that outboard position.
WARNING!
• Use anchorages C and D to install a LATCH-
compatible child restraint in the center seating
position (2). Do not install a LATCH-
compatible child restraint using anchorages B
and C. This is not a LATCH-compatible posi-
tion in your vehicle.
• Never use the same lower anchorage to attach
more than one child restraint. Please refer to
"Installing A LATCH-Compatible Child Re-
straint System" for typical installation instruc-
tions.
Always follow the directions of the child restraint
manufacturer when installing your child re-
straint. Not all child restraint systems will be in-
stalled as described here.
135