Configuring Gts; Configuring The Line Rate - HP 5920 Configuration Manual

Step
6. Configure a traffic
policing action.
7. Return to system view.
8. Create a QoS policy
and enter QoS policy
view.
9. Associate the traffic
class with the traffic
behavior in the QoS
policy.
10. Return to system view.
11. Apply the QoS policy.
12. (Optional.) Display
traffic policing
configuration
information.

Configuring GTS

The switch supports configuring queue-based GTS by using the non-MQC approach. In queue-based
GTS, you set GTS parameters for packets of a certain queue.
To configure GTS:
Step
1. Enter system view.
2. Enter interface view.
3. Configure GTS for a
queue.

Configuring the line rate

The line rate of a physical interface specifies the maximum rate of incoming packets or outgoing packets.
To configure the line rate:
Command
car cir committed-information-rate [ cbs
committed-burst-size [ ebs
excess-burst-size ] ] [ pir
peak-information-rate ] [ green action |
red action | yellow action ] *
quit
qos policy policy-name
classifier classifier-name behavior
behavior-name
quit
•
Applying the QoS policy to an
interface
•
Applying the QoS policy to a VLAN
•
Applying the QoS policy globally
•
Applying the QoS policy to the
control plane
display traffic behavior user-defined
[ behavior-name ]
Command
system-view
interface interface-type interface-number
qos gts queue queue-number cir
committed-information-rate [ cbs
committed-burst-size ]
38
Remarks
By default, no traffic policing action is
configured.
N/A
By default, no QoS policy is
configured.
By default, a traffic class is not
associated with a traffic behavior.
N/A
Choose one of the application
destinations as needed.
By default, no QoS policy is applied.
Available in any view.
Remarks
N/A
N/A
By default, GTS is not configured
on an interface.