Defining A Class - HP 5830 Series Configuration Manual

Figure 4 QoS policy configuration procedure

Defining a class

This section describes how to define a class.
Configuration guidelines
If a class that uses the AND operator has multiple if-match acl, if-match acl ipv6, if-match
customer-vlan-id or if-match service-vlan-id clauses, a packet that matches any of the clauses matches
the class.
To successfully execute the traffic behavior associated with a traffic class that uses the AND operator,
define only one if-match clause for any of the following match criteria, and enter only one value for any
of the following list arguments (for example, the 8021p-list argument):
customer-dot1p 8021p-list
•
destination-mac mac-address
•
dscp dscp-list
•
• ip-precedence ip-precedence-list
service-dot1p 8021p-list
•
source-mac mac-address
•
To create multiple if-match clauses for these match criteria or specify multiple values for the list arguments,
specify the operator of the class as OR and use the if-match command multiple times.
Configuration procedure
To define a class:
17