Installation; Connect Power - Uniden CMX660 Owner's Manual

INSTALLATION

You can install the CMX660 either on top/
underneath a flat surface like a dashboard or
under the driver's seat in a vehicle. Select a location
that is convenient for operating the radio but does not
interfere with the driver or passenger.
Plan the location of the radio and microphone
brackets before beginning installation.
Check the engine compartment and adjust
wiring that may interfere with bracket
The basic steps to install this unit are:
•

Connect Power

• Connect Antenna
• Install Microphone Hanger/Connect
Microphone
• Install Radio Bracket/Install Radio
CONNECT POWER
Uniden recommends connecting the power lead
to the Ignition Switch Accessory Terminal. This
way, the radio is automatically turned off when the
ignition switch is turned off.
As an alternative, the power cord may be
connected to an available terminal on the fuse
block or to a point in the wiring harness. However,
be careful not to create a short circuit. If in doubt,
contact your vehicle dealer for information.
10
installation.