Getting Started; Battery Installation - Uniden UH515DLX-2 Owner's Manual

Getting Started

Uniden does not represent this product to be waterproof. Do not
expose this product to Rain or Moisture.
NOTE

Battery Installation

Your UH515SX-2NB/UH515DLX-2 unit uses the included NiMH battery pack
for power.
The unit can be powered with optional 3 AAA ALKALINE batteries*.
*The TX power is always low for alkaline batteries.
If you don't use the UH515SX-2NB/UH515DLX-2 for long
periods, Uniden recommends removing the batteries.
NOTE
To avoid damage to the unit do not mix old and new batteries.
To install the batteries:
1. Make sure your radio is off.
2. Release the battery cover clip, then remove the battery cover.
3. Insert NiMH battery pack according to the orientation on the battery pack.
OR
Insert 3 AAA ALKALINE batteries (not included) according to the polarity
symbols inside the battery compartment.
4. Align the battery cover tabs with the UH515SX-2NB/UH515DLX-2 tab
holes then replace the cover clip.
Do not charge alkaline or non rechargeable batteries.
NOTE
UNIDEN UH515SX-2NB/UH515DLX-2
2
UHF CB Radio