Installation - Uniden PRO 510XL Manual

Connect the microphone
Align the microphone connector with the jack on the front of the radio. Push
the connector in firmly and secure it with the locking screw.
Connect the power
You can connect the radio to any standard 12 volt DC power source with a
negative ground. If you don't know whether your power supply uses a negative
ground, consult the manual for your power supply or contact the manufacturer.
WARNING! DO NOT connect this equipment to a power supply if you are
not absolutely certain of the grounding type!
1) Make sure your power supply is turned off.
2) Connect the RED lead on the radio to the power supply's POSITIVE (+)
pole, and connect the BLACK lead to the power supply's NEGATIVE (–)
pole or to a neutral ground such as the chassis.
3) Turn on your power supply.
4) Turn the radio's Volume knob clockwise to power on the radio.
Installing the mounting bracket
When choosing the location for the radio's mounting bracket, keep the
following things in mind:
► Pick a location that does not block your view, interfere with your vehicle's
controls, or hinder your driving.
► Make sure the radio and microphone are not in front of an airbag.
► Pick a solid surface that can support the weight of the bracket and the
radio.
► Make sure there's enough room. (You may want to put the radio in the
bracket when you're choosing where to install the bracket.)
Once you choose the location, use the included, self-tapping screws to attach
the mounting bracket and the microphone bracket to your vehicle (you don't
have to drill holes). Slide the radio into the bracket and use the included knobs
to hold it at the preferred angle.
Connecting an external antenna
You will need to purchase an antenna to operate the radio. However, Your
Uniden dealer can help you select the antenna that is best for your needs.
Consult the specifications in the back of this manual for detailed transmitter
and antenna information.

INSTALLATION

6