Product Safety; Section 7 Product Safety - Steel City 25200 User Manual

25. USE ONLY recommended accessories. Use of
incorrect or improper accessories could cause seri-
ous injury to the operator and cause damage to the
machine. If in doubt, DO NOT use it.
26. Wear proper clothing, DO NOT wear loose clothing,
gloves, neckties, or jewelry. These items can get
caught in the machine during operations and pull
the operator into the moving parts. Users must
wear a protective cover on their hair, if the hair is
long, to prevent it from contacting any moving parts.
27. SAVE these instructions and refer to them frequent-
ly and use them to instruct other users.
1. Serious personal injury may occur if normal safety
precautions are overlooked or ignored. Accidents
are frequently caused by lack of familiarity or failure
to pay attention. Obtain advice from supervisor,
instructor, or another qualified individual who is
familiar with this machine and its operations.
2. Every work area is different. Always consider safe-
ty first, as it applies to your work area. Use this
machine with respect and caution. Failure to do so
could result in serious personal injury and damage
to the machine.
3. Prevent electrical shock. Follow all electrical and
safety codes, including the National Electrical Code
(NEC) and the Occupational Safety and Health
Regulations (OSHA). All electrical connections and
wiring should be made by qualified personnel only.
WARNING
!
4. TO REDUCE the risk of electrical shock. DO
NOT use this machine outdoors. DO NOT
expose to rain or moisture. Store indoors in a
dry area.
5. STOP using this machine, if at any time you experi-
ence difficulties in performing any operation.
Contact your supervisor, instructor or machine serv-
ice center immediately.
28. Information regarding the safe and proper operation

PRODUCT SAFETY

6. Safety decals are on this machine to warn and
7. DO NOT leave the unit plugged into the electrical
8. ALWAYS turn the power switch "OFF" before
!
9. DO NOT handle the plug or mortiser with
10. USE accessories only recommended by Steel City.
11. DO NOT pull the mortiser by the power cord.
12. DO NOT unplug the mortiser by pulling on the
13. REPLACE a damaged cord immediately. DO NOT
11
of this tool is also available from the following
sources:
Power Tool Institute
1300 Summer Avenue
Cleveland, OH 44115-2851
www.powertoolinstitute.org
National Safety Council
1121 Spring Lake Drive
Itasca, IL 60143-3201
American National Standards Institute
25West 43rd. St, 4th Floor
New York, NY. 10036
ANSI 01.1 Safety Requirements
For Woodworking Machines
WWW.ANSI.ORG
U.S. Department of Labor Regulations
OSHA 1910.213 Regulations
WWW.OSHA.GOV
direct you to how to protect yourself or visitors from
personal injury. These decals MUST be maintained
so that they are legible. REPLACE decals that are
not legible.
outlet. Unplug the unit from the outlet when not in
use and before servicing, performing maintenance
tasks, or cleaning.
unplugging the mortiser.
WARNING
wet hands.
NEVER allow the power cord to come in contact
with sharp edges, hot surfaces, oil or grease.
power cord. ALWAYS grasp the plug, not the cord.
use a damaged cord or plug. DO NOT USE if the
mortiser is not operating properly, or has been dam-
aged, left outdoors or has been in contact with
water.