Table of Contents
Advertisement
DEPTH STOP ROD
The depth stop rod is provided to limit the cutting depth
of the chisel. To adjust the depth stop rod (A), loosen
set screw (B). SEE FIG. 23.
Fig. 23
1. Lower head until the cutting chisel (C) is at the
desired depth. SEE FIG. 24.
Fig. 24
C
2. Lower depth stop rod until it contacts the top of the
column (D).
3. Tighten set screw (E).
ADJUSTMENTS
A
B
E
D
21
FENCE
The fence can be moved in or out to accommodate var-
ious size workpieces.
To move fence:
1. Loosen fence lock handle (A) until the fence glide
shaft (B) can move freely. SEE FIG. 25.
2
Slide fence (C) in or out to the desired position.
3. Tighten fence lock handle to secure fence.
Fig. 25
A
B
MICRO-ADJUST ASSEMBLY
Sometimes it is necessary to move the fence in small
increments. When this is the case, the micro-adjust
assembly should be used.
1
Loosen the fence lock handle (A) so that the fence
(C) may slide smoothly. SEE FIG. 25.
2. Rotate the adjustment knob (D) clockwise to move
the fence in towards the mortiser column. Rotate
counterclockwise to move the fence away from the
mortiser column.
C
D
Hide quick links:
Advertisement
Table of Contents
