Trimming Sawgear Tables; Sawgear Bench Mount Brackets; Secure Sawgear In The Brackets; Dismounting Sawgear From The Saw Stand - SawGear SGTAB04 Manual

Trimming SawGear Tables

Some miter saws have a range of motion that would cause the saw to cut into the SawGear
table. It is ok to trim the corner of the SawGear table to accommodate saws with a wider range
of motion.

SawGear Bench Mount Brackets

SawGear comes with two (2) bench mount
brackets. To order additional, use order# BR-
BM.

Secure SawGear in the brackets

1. Make sure both bracket mounts are approxi-
mately in line. Fasten them down with the
supplied hardware.
2. Lay SawGear across both bracket mounts in the
desired position relative to the saw.
3. When SawGear is facing front, there is an
angled channel running along the full length of
the beam at the bottom. Pivot SawGear, so the
curled front edge of both SawGear bench mount
brackets fits into this channel.
4. Let SawGear lie flat against the surface of both
brackets, so the beveled back lip of the Saw-
Gear beam can be secured by the locking
knobs.
5. Turn the locking knobs to capture SawGear in
both bench mount brackets.

Dismounting SawGear from the saw stand

SawGear is easily dismounted from the saw stand by loosening the locking knobs and pivoting
it off the brackets.
Always be sure to firmly tighten the locking knobs and all fasteners before using SawGear.
3
7