Entering Feet, Inches And Fractions - SawGear SGTAB04 Manual

The dimension displays exactly as you entered it. In Foot mode, inches is assumed.
When you press [Start], SawGear
moves immediately to the length
entered and displays its current
position.
5. Press [Start] to advance to the
next line in the cut list.
6. Enter [2] [3] [In] [7] [8] and press
[Start].
When entering inches and a fraction, use the [In] key to separate the fraction. When you
press [Start], SawGear moves immediately to the length entered and displays its current
position.
At any point you can exit the list by pressing [STOP] and the dimensions will be saved.
7. Press [Start] to advance to the
next line in the cut list.
Enter as many as 9 different dimensions into a list.
8. Press [STOP] to exit a list.

Entering Feet, Inches and Fractions

The following examples show how to enter dimensions into SawGear and how it interprets the
data.
1. Enter [6].
2. Press [Start].
SawGear moves to position at 6 inches.
RULE: When neither [Ft] nor [In] are pressed, SawGear assumes Inches when in Foot mode.
DISPLAY: In Foot mode, if there are inches, when at position the last two digits are
ALWAYS "in".
3. Enter [5] [/] [8].
4. Press [Start].
SawGear moves to position at 5/8 inch.
RULE: When [/] is used in a dimension, SawGear assumes Inches when in Foot mode.
SawGear is in Foot mode for these examples.
21
25