Start Sawgear; Set Sleep Mode; Set Contrast - SawGear SGTAB04 Manual

If SawGear is plugged into power but does not display the active screen, start it up using the
soft start key:
SawGear will automatically power off the display when not in use, unless sleep mode is
turned off.
•When powered ON, SawGear emits a low hum, which indicates that SawGear is ON and
ready to use.
•When powered OFF using the soft start key, the hum stops, indicating that SawGear is
OFF.
•To power it ON again, push the soft start, and listen for the hum. The display will also come
on.
•If you have turned on Password Protection, then the password MUST be entered whenever
SawGear has to be powered on.
SawGear will automatically power OFF after ten minutes of inactivity. This puts it in 'sleep
mode.'
Start it up again using the soft start key:
Sleep mode can be turned off, or the length of time before going into sleep mode can be
changed.
1. Press and then
2. Press [0] to turn sleep mode OFF,
and [Start] to save the setting.
Your SawGear will never automatically power OFF.
3. OR, enter a number to set how many minutes SawGear can be inactive before it powers
OFF in sleep mode, and then press [Start] to save the setting.
The smallest number you can enter is 0.25 minutes. Your entry can include a decimal
fraction.
The SawGear power head screen contrast can be adjusted to lighten or darken the screen.
Press and then

Start SawGear

Set Sleep Mode

.

Set Contrast

V2.08 or higher
.
11
15