Deactivate The Password - SawGear SGTAB04 Manual

2. While holding down the [/] key, plug SawGear into AC power.
3. Enter the old password and press [Start].
4. Enter a new password consisting
of 4 to 8 digits, and press [Start].
5. Re-enter password and press
[Start].
6. Press [Start].
SawGear homes itself and then
scrolls:
SawGear is now ready to use!
When password protection has been set, it can also be turned off.
The following steps show how to deactivate password protection.
The messages shown below SCROLL across the screen if longer than the LCD's 16
1. Unplug SawGear from AC power.
2. While holding down the [/] key,
plug SawGear into AC power.
3. Enter the old password and press [Start].
4. Press [Start] [Start].
5. Press [Start] [Start] again.
This clears the password.
6. Press [Start].
SawGear homes itself and then scrolls:
SawGear is now ready to use!

Deactivate the Password

character width.
13
17