Setting The Distance Between The Stop And The Blade; Calibrate Straight Cut Distance; Calibrate Miter Cut X Distance - SawGear SGTAB04 Manual

SawGear is no longer password protected and will not ask for a password when it is powered
up
Setting the Distance Between the Stop and
This is how to set the distance between the stop and the saw blade using the
Calibrate key:

Calibrate Straight Cut Distance

1. Cut a sample board at least 12 inches long.
2. Measure the cut board, and press [-D-].
The LCD screen scrolls:
3. Enter the actual length of the sample piece and press [Start] to return to the ready screen.

Calibrate Miter Cut X Distance

•The calibration of the X, Y and Z values uses a calculated value based on the value of W
(moulding width).
•SawGear will use whatever was the last known value of W to calibrate X, Y and Z values.
•See also Setting the Value of W.
18
the Blade
SawGear is in Foot mode for these examples.
The Calibrate key will let you set five distances:
1.Between stop and saw blade (straight cut distance)
2.Between stop and saw blade at 45° angle miter (X distance)
3.Between stop and saw blade at 45° angle miter (Y distance)
4.Between stop and saw blade at 45° angle miter (Z distance)
5.Between stop and saw blade (stored increment)
14