Home Routine After Impact - SawGear SGTAB04 Manual

•If material is thrust against SawGear with sufficient force, it can possibly bump the stop off
position.
•Whether it does or not, a warning message appears to allow you to re-home the machine,
or continue working.
•If you think the machine might have been knocked off position, choose to re-home it.
•If you are confident it did not move, choose to continue working.
The messages shown below SCROLL across the screen if longer than the LCD's 16
After significant impact, the screen
displays:
OPTION 1: Re-home SawGear.
•Press [Start].
SawGear homes itself and then
scrolls:
OPTION 2: Keep working.
•Press [Stop].
The display shows the current position.
•Enter a length and press [Start].
Calibration adjusts the screen position to match the actual position at a single point. If accuracy
decreases as you move away from the calibration point, then the SawGear should be scaled.
• Unplug.
• Unplug.
• Plug back in.
• Plug back in.
• Press power, then hit calibrate three times.
• Press power, then hit calibrate three times.
• If the long cuts are too long, increase the working length by 0.03". Or vice versa.
• If the long cuts are too long, increase the working length by 0.03 inches (0.8 mm) or vice versa.
• Start through the other options
• Press start to cycle through the other settings.
(these include throttles and scale)
Throttle defaults to 300 inches (7,620 mm).
(throttles are 300 inches and 8000 inches)
Throttle base defaults to 8,000 inches (203,200 mm).
(speed is 25 ips, scale defaults to 3.047 inches, but you musst allow it to float
Scale defaults to 3.047 inches (77.4 mm), but you must allow this setting to float as you
as you change the working length)
change the working length.
• Now it moves to the back and says ready to work.
• Now it moves to the back and says ready to work.
• Calibrate short.
• Calibrate short.
• Cut long.
• Cut long.
• Repeat if necessary.
• Repeat if necessary.
30

Home Routine after Impact

Scaling Instructions
Scaling Instructions
character width.
26