Largest Number Display; Entering Feet And Decimal Inches - SawGear SGTAB04 Manual

5. Enter [6] [In] [5] [/] [8].
6. Press [Start].
SawGear moves to position at 6-5/8 inches.
DISPLAY: Inches are separated from fractions by an underscore when at position.
7. Enter [8] [Ft] [6] [In] [5] [/] [8].
8. Press [Start].
SawGear moves to position at 8 feet 6-5/8 inches.
DISPLAY: Feet is ALWAYS followed by "Ft" and is separated from Inches by a space
when at position.
9. Enter [8] [Ft] [6].
10. Press [Start].
SawGear moves to position at 8 feet 6 inches.
RULE: Any number entered after [Ft] is interpreted as Inches.
11. Enter [6] [Ft].
12. Press [Start].
SawGear moves to position at 6 feet.
RULE: Any number in whole feet with neither inches nor fractions must be followed by [Ft], oth-
erwise the number will be interpreted as Inches.
DISPLAY: If a dimension is entered in feet and no inches, "0in" will ALWAYS display at
the end of the number when at position.

Largest Number Display

The LCD display has 16 characters available, which limits the maximum number.
SawGear is in Foot mode for this example.
The number of feet is related to SawGear working
length.

Entering Feet and Decimal Inches

The following examples show how to enter dimensions into SawGear and how it interprets the
data.
SawGear is in Foot mode for these examples.
1. Enter [0] [.] [8] [7] [5].
2. Press [Start].
SawGear moves to position at 0.875 inches.
26
22