SawGear SGTAB04 Manual page 22

Getting Started
Turning the Crown & Miter Pro feature ON
1. To activate the Crown & Miter Pro feature, Simply
press the [W] key twice.
2. Type [0] then the [Start] key.
Measuring Angles and Lengths
Crown & Miter Pro works best if, going counter clockwise around the room, you make a list of
angles and cut lengths. See Table 1.
Note - If doing base moulding, you will want to work clockwise around the room.
Table 1:
First Angle
Length
45° Outside
90° Outside 21 3/16 in
81.5° Inside 7 3/8 in
How to use Crown & Miter Pro
Once we have a list compiled, we can start using the system.
[W] Key
The [W] key is used to set the width of the molding.
[X] Key
In Crown & Miter Pro mode, the [X] key acts as the first angle of your part. Press the [X] key,
and the following screen will display;
Enter the first angle of the piece you want to cut, then use the [increm] key to select if this is an
inside or outside corner. As you type the angle the angle the saw will need to be set to will dis-
play. You will also see < for Left or > for Right. This will tell you which direction to set the saw
angle.
22
These buttons, located along the top of the SawGear control,
are used to set angles once the Crown & Miter Pro feature is
turned ON.
Piece
Final Angle
5 in 90° Outside
81.5° Inside
90° Inside
A is the angle. S is the saw angle you will need to set.
18