Advertisement
A. GENERAL INSTRUCTIONS
Please read the enclosed instructions carefully as they include important points
about safety for the installation, usage and maintenance of the unit.
• Please keep this booklet with the unit for future consultation. If you sell the unit to
another user, be sure that the new user also receives this instruction booklet thus
giving them the necessary information about the use and general warnings
regarding the unit.
• Before the initial start-up, please unpack and carefully check all components in
case any damage may have occurred during shipping.
• Locate a suitable spot for your device where there is good ventilation. Also, make
sure that no ventilating fans or slots are blocked.
• Protect our environment! Please dispose of the packing boxes properly.
• The electrical work that is necessary for installation must be done by qualified
personnel.
• Always remember to unplug the unit from the power mains before any service is
done. Do not open the unit, there are no serviceable parts inside.
• It is very important to ground the yellow/green conductor to earth in order to meet
regulations for safety.
• Check the surrounding area and make sure there are no flammable liquids, water
or metal objects that could enter the fixture. If a foreign object enters the unit,
immediately disconnect the main power. Also, place the fixture in a
well-ventilated room at about 15 cm from the walls.
• Do not touch any wires during operation, as high voltage might be hazardous.
• I n the event of serious operating problems, stop using the unit immediately. Never
try to repair the unit yourself. Repairs carried out by unqualified personnel can
lead to damage or malfunction. Please contact the nearest authorized Technical
Assistance Center. Always use genuine spare parts.
E. FIXTURE CLEANING
The cleaning of internal and external optical lenses and/or mirrors must be
carried out periodically to optimize light output. Cleaning frequency depends on the
environment in which the fixture operates: damp, smoky or particularly dirty
surrounding can cause greater accumulation of dirt on the unit's optics.
•
Clean with a soft cloth using normal glass cleaning products.
•
Always dry the parts carefully.
•
Clean the external optics at least once every 20 days. Clean the internal optics
at least every 30/60 days.
3B
For further requirements, contact the nearest authorized technical assistance center.
Advertisement
